Checking/Adjusting Headlight Aim; Fuses - Arctic Cat Alterra TRV 700 Operator's Manual

2. Insert the taillight and heat shield (left
rear only) into position and secure
with existing screws. Tighten the
screws securely; then connect the
wiring harness.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The geometric center of the HIGH beam
light zone is to be used for aiming.
1. Position the ATV on a level floor so
the headlights are approximately 6.1 m
(20 ft) from an aiming surface (wall or
similar aiming surface).

NOTE: There should be an aver-
age operating load on the ATV when
adjusting the headlight aim.
2. Measure the distance from the floor to
the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming sur-
face directly in front of the headlights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. To adjust the headlights, loosen the
adjustment knob. After proper adjust-
ment is achieved, tighten the knob
securely.
XR241A

Fuses

The fuses are located under the driver's
seat. Remove both seats to access the
fuses. If there is any type of electrical
system failure, always check the fuses
first.
0748-548
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
dealer immediately.

NOTE: To remove the fuse, com-
press the locking tabs on either side
of the fuse cover and lift out.
CAUTION
XR065B
XR244A
65