Setting The Gp-Ib Control - YOKOGAWA WT3001E User Manual

1.5

Setting the GP-IB Control

Procedure
Explanation
IM WT3001E-17EN
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
1. Press MISC to display the Misc menu.
2. Press the Remote Control soft key to display the Remote Ctrl menu.
Press the Device soft key to select GP-IB.
3.
Only the communication interface selected here is enabled. This instrument does not
accept commands that are transmitted to other unselected communication interfaces.
Press the cursor keys to set the address.
4.
Enter the following settings when using a controller to set information that can be
specified through key operation on this instrument or when outputting setup parameters
or output waveform display data to the controller.
Address
Set the address of this instrument within the following range for the addressable mode.
0 to 30
Each device that can be connected via GP-IB has a unique address within the GP-IB
system. This address is used to distinguish the device from others. Therefore, when you
connect this instrument to a PC, for example, make sure to assign a unique address to
this instrument.
Note
Do not change the address while the controller or other devices are using the GP-IB system.
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
ELEMENT
LOWER ITEM LOWER FORM USER SET
To exit the menu during operation, press ESC located above
the soft keys.
In the procedural explanation below, the phrase "press the
cursor keys" may be used. This phrase refers to the
procedures for selecting items and entering values and
character strings. For details on the procedures, see section
3.14 in the User's Manual, IM WT3001E-01EN.
REMOTE
UPDATE
HOLD LOCAL
RATE
SINGLE
CAL
INTEG
SHIFT
START STOP
ALL
1
2
3
4
5
6
7
App
Index
1-5