Remote Control Input/Output Signal (/Da4, /Da12 Options); Gp-Ib Interface (Standard On -C1); Serial (Rs-232) Interface (Standard On -C2); 7.10 Usb Pc Interface - YOKOGAWA WT332 User Manual

7.7 Remote Control Input/Output Signal
(/DA4, /DA12 Options)
Item
Remote control input signal
Remote control output signal
I/O level
I/O logic format
7.8

GP-IB Interface (Standard on -C1)

Item
Usable devices
Electrical and mechanical
Functional specifications
Protocol
Code
Mode
Addresses
Clear remote mode
7.9

Serial (RS-232) Interface (Standard on -C2)

Item
Connector type
Electrical specifications
Connection
Transmission mode
Synchronization
Baud rate

7.10 USB PC Interface

Item
Number of ports
Connector
Electrical and mechanical
specifications
Supported transfer modes
Supported protocols
PC system requirements
IM WT310-02EN
Specifications
EXT HOLD, EXT TRIG, EXT START, EXT STOP, EXT RESET
INTEG BUSY
TTL
Negative logic, falling edge
Specifications
National Instruments Corporation
• PCI-GPIB or PCI-GPIB+
• PCIe-GPIB or PCIe-GPIB+
• PCMCIA-GPIB or PCMCIA-GPIB+
(not supported on Windows Vista or Windows 7.)
• GPIB-USB-HS
Use driver NI-488.2M Ver. 2.8.1 or later.
Complies with IEEE St'd 488-1978 (JIS C 1901-1987)
SH1, AH1, T6, L4, SR1, RL1, PP0, DC1, DT1, C0
Complies with IEEE St'd 488.2-1992
ISO (ASCII) codes
Addressable mode
0 to 30
Press LOCAL to clear remote mode (except during Local Lockout).
Specifications
D-Sub 9-pin (plug)
Complies with EIA-574 (EIA-232 (RS-232) standard for 9-pin)
Point to point
Full duplex
Start-stop synchronization
Select from 1200, 2400, 4800, 9600, 19200, 38400 or 57600 bps.
Specifications
1
Type B connector (receptacle)
Complies with USB Rev. 2.0
HS (High Speed; 480 Mbps) and FS (Full Speed; 12 Mbps)
USBTMC-USB488 (USB Test and Measurement Class Ver. 1.0)
A PC with a USB port, running the English or Japanese version of Windows 7 (32 bit/64bit),
Windows Vista (32 bit), or Windows XP (32 bit, SP2 or later)
1
2
3
4
5
6
7
App
Index
7-15