Setting The Ethernet Control - YOKOGAWA WT3001E User Manual

4.3

Setting the Ethernet Control

Prcedure
4-4
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET
FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
Selecting the Ethernet Control
1. Press MISC to display the Misc menu.
2. Press the Remote Control soft key to display the Remote Ctrl menu.
3. Press the Device soft key and select Network.
Only the communication interface selected here is enabled. This instrument does not
accept commands that are transmitted to other unselected communication interfaces.
DISPLAY ITEM & ELEMENT
U / I / P
NUMERIC WAVE
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
To exit the menu during operation, press ESC located above
the soft keys.
In the procedural explanation below, the phrase "press the
cursor keys" may be used. This phrase refers to the
procedures for selecting items and entering values and
character strings. For details on the procedures, see section
3.14 in the User's Manual, IM WT3001E-01EN.
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
IM WT3001E-17EN
REMOTE
LOCAL
SHIFT