Setting The Usb Control - YOKOGAWA WT3001E User Manual

3.4

Setting the USB Control

Procedure
3-4
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
Selecting USB Control
1. Press MISC to display the Misc menu.
2. Press the Remote Control soft key to display the Remote Ctrl menu.
3. Press the Device soft key and select USB.
Only the communication interface selected here is enabled. This instrument does not
accept commands that are transmitted to other unselected communication interfaces.
Press the cursor keys to set the ID value.
4.
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
FORM USER
ITEM
LOWER ITEM LOWER FORM USER SET
To exit the menu during operation, press ESC located above
the soft keys.
In the procedural explanation below, the phrase "press the
cursor keys" may be used. This phrase refers to the
procedures for selecting items and entering values and
character strings. For details on the procedures, see section
3.14 in the User's Manual, IM WT3001E-01EN.
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
IM WT3001E-17EN
REMOTE
LOCAL
SHIFT