YOKOGAWA WT3001E User Manual page 60

6.1 List of Commands
Command
Common Command Group
*CAL?(CALibrate)
*CLS(CLear Status)
*ESE
(standard Event Status Enable
register)
*ESR?(standard Event Status
Register)
*IDN?(IDeNtify)
*OPC(OPeration Complete)
*OPC?(OPeration Complete)
*OPT?(OPTion)
*PSC(Power-on Status Clear)
*RST(ReSeT)
*SRE(Service Request Enable
register)
*STB?(STatus Byte)
*TRG(TRiGger)
*TST?(TeST)
*WAI(WAIt)
6-16
Function
Executes zero calibration (zero-level compensation, same operation as
pressing CAL (SHIFT+SINGLE)) and queries the result.
Clears the standard event register, extended event register, and error queue. 6-114
Sets the standard event enable register or queries the current setting.
Queries the standard event register and clears the register.
Queries the instrument model.
Sets bit 0 (OPC bit) of the standard event register to 1 upon the completion
of the specified overlap command.
ASCII code "1" is returned when the specified overlap command is
completed.
Queries the installed options.
Sets whether to clear the registers below at power on or queries the current
setting. The register is cleared when the value rounded to an integer is a
non-zero value.
Initializes the settings.
Sets the service request enable register or queries the current setting.
Queries the status byte register.
Executes single measurement (the same operation as when SINGLE is
pressed).
Performs a self-test and queries the result.
Holds the subsequent command until the completion of the specified overlap
operation.
Page
6-114
6-114
6-114
6-114
6-115
6-115
6-115
6-115
6-115
6-115
6-116
6-116
6-116
6-116
IM WT3001E-17EN