Conventions Used In This Manual - YOKOGAWA WT3001E User Manual

Conventions Used in This Manual

Note
Subheadings
Prefixes k and K
Symbols Used in the Syntax
iv
Note
Calls attention to information that is important for the proper
operation of the instrument.
On pages that describe operating procedures, the following symbols, displayed
characters, and terminology are used to distinguish the procedures from their
explanations:
Follow the numbered steps. All procedures are written with
Procedure
inexperienced users in mind; experienced users may not need to
carry out all the steps.
This subsection describes the setup parameters and the limitations
Explanation
on the procedures.
Displayed Characters and Terminology Used in the Procedural Explanations
Panel Keys and Soft keys
Bold characters used in the procedural explanations indicate characters that are marked on the
panel keys or the characters of the soft keys or menus displayed on the screen.
SHIFT + Panel Key
SHIFT + key means you will press the SHIFT key to turn ON the SHIFT key followed by the
operation key. The setup menu marked in purple below the panel key that you pressed appears
on the screen.
Prefixes k and K used before units are distinguished as follows:
k Denotes 1000. Example: 100 kHz
K Denotes 1024. Example: 640 KB (file data size)
Symbols which are used in the syntax descriptions in Chapter 6 are shown below.
These symbols are referred to as BNF (Backus-Naur Form) symbols. For details on
the data, see section 5.4.
Symbol Meaning
<>
Defined value.
{}
Select from values
given in { } .
|
Exclusive OR
[]
Can be omitted.
Example
ELEMent<x> <x> = 1 to 4
MODE:{RMS|MEAN|DC|RMEAN}? ->MODE:RMS?
NUMeric[:NORMal]:VALue?
Example of Input
->ELEMENT2
->NUMERIC:VALUE?
IM WT3001E-17EN