Table of Contents
Advertisement
Address Setting Range
Talk-Only Function
Setting the GP-IB Interface
IM 767361-01E
0–30
The factory setting is 1.
This function only allows the instrument to send measured or computed data
to other devices. Even if the instrument is not assigned as a talk-only device,
it can still send data. In talk-only mode, the instrument cannot be controlled by
the controller.
1.
Press MENU.
Keep pressing
or
then press ENTER/LOCAL.
Proceed to step 2 when using the battery pack or DC power supply.
Proceed to step 3 when using the AC power supply.
2.
Use the
and
to set the GP-IB function (
: Activates the function.
: Deactivates the function.
3.
Press
or
to select
then confirm the selection by pressing ENTER/LOCAL.
4.
If addressable mode is selected, keep pressing
blink, then set the desired value by pressing
then press ENTER/LOCAL.
5.
Press MENU to return to the normal measurement screen.
Overview of the GP-IB Interface
until
is displayed in the lower part of the screen,
(addressable mode) or
until the desired digit starts to
or
) and press ENTER/LOCAL.
(talk-only mode),
to set the address (
),
53
Advertisement
Table of Contents
