Org-Specific Tlv Setting - ZyXEL Communications GS1920v2 Series User Manual

Table 139 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
L ABEL
Management
Address
Port Description
System Capabilities
System Description
System Name
Apply
Cancel
33.6.2 O rg - spe c ific T L V Se tting
Use this screen to configure organization-specific TLV settings. Click
C o nfig ura tio n (C lic k He re ) > O rg - spe c ific T L V Se tting
Advanced Application > LLDP > LLDP Configuration> Org-specific TLV Setting
Fig ure 216
The following table describes the labels in this screen.
Table 140 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
L ABEL
Port
*
Dot1 TLV
Port-Protocol
VLAN ID
Chapter 33 Link Layer Discovery Protocol (LLDP)
DESC RIPT IO N
Select the check box(es) to enable or disable the sending of Management Address TLVs on
the port(s).
Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
Select the check box(es) to enable or to disable the sending of System Capabilities TLVs on
the port(s).
Select the check box(es) to enable or to disable the sending of System Description TLVs on
the port(s).
Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
DESC RIPT IO N
This displays the Switch's port number.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs on the port(s).
GS1920v2 Series User's Guide
301
link on the top navigation panel to
Sa ve
Adva nc e d Applic a tio n
to display the screen as shown next.
>
L L DP > L L DP