Port Details - ZyXEL Communications GS1920v2 Series User Manual

Table 195 Port Status (continued)
L ABEL
State
PD
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter
50.2.1 Po rt De ta ils
Click a number in the
screen to check status and detailed performance data about an individual port on the Switch.
Chapter 50 Port Status
DESC RIPT IO N
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port.
13.1 on page 135 for more information.
If STP is disabled, this field displays
When LACP (Link Aggregation Control Protocol), STP, and dot1x are in blocking state, it displays
.
Blo c king
For PoE model(s) only.
This field displays whether or not a powered device (PD) is allowed to receive power from the
Switch on this port.
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on the
port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has been up.
Select , enter a port number and then click
Po rt
information for that port, or select
column in the
Po rt Po rt Sta tus
GS1920v2 Series User's Guide
if the link is up, otherwise, it displays
FO RWARDING
C le a r C o unte r
to clear statistics for all ports.
Any
screen to display individual port statistics. Use this
393
SeeSection
.
ST O P
to erase the recorded statistical