ZyXEL Communications GS1920v2 Series User Manual page 117

Advanced Application > VLAN > VLAN Configuration > Subnet Based VLAN Setup
Fig ure 91
Note:
The following table describes the labels in this screen.
Table 40 Advanced Application > VLAN > VLAN Configuration > Subnet Based VLAN Setup
L ABEL DESC RIPT IO N
Active Check this box to activate this subnet based VLANs on the Switch.
DHCP-Vlan When DHCP snooping is enabled DHCP clients can renew their IP address through the DHCP VLAN
Override or via another DHCP server on the subnet based VLAN.
Select this checkbox to force the DHCP clients in this IP subnet to obtain their IP addresses through
the DHCP VLAN.
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Active Check this box to activate the IP subnet VLAN you are creating or editing.
Name Enter up to 32 alpha numeric characters to identify this subnet based VLAN.
IP Enter the IP address of the subnet for which you want to configure this subnet based VLAN.
Mask-Bits Enter the bit number of the subnet mask. To find the bit number, convert the subnet mask to
binary format and add all the 1's together. Take "255.255.255.0" for example. 255 converts to
eight 1s in binary. There are three 255s, so add three eights together and you get the bit number
(24).
VID Enter the ID of a VLAN with which the untagged frames from the IP subnet specified in this subnet
based VLAN are tagged. This must be an existing VLAN which you defined in the
Applic a tio ns
Priority Select the priority level that the Switch assigns to frames belonging to this VLAN.
Add Click
Add
if it is turned off or loses power, so use the
changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Index This is the index number identifying this subnet based VLAN. Click on any of these numbers to edit
an existing subnet based VLAN.
Chapter 9 VLAN
to save your changes to the Switch's run-time memory. The Switch loses these
> screens.
VL AN
to save your changes to the Switch's run-time memory. The Switch loses these changes
to begin configuring this screen afresh.
GS1920v2 Series User's Guide
117
link on the top navigation panel to save
Sa ve
link on the top navigation panel to save your
Sa ve
Adva nc e d