Save Configuration; Reboot System - ZyXEL Communications GS1920v2 Series User Manual

In the web configurator, click the
3
If you want to access the Switch web configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).
39.2.2 Sa ve C o nfig ura tio n
Click
C o nfig 1
configurations are set up according to your network environment.
Click
C o nfig 2
configurations are set up according to your network environment.
Click
C usto m De fa ult
Alternatively, click
to the current configuration.
Note: Clicking the
unsaved changes are erased after you reboot the Switch.
39.2.3 Re b o o t Syste m
Re b o o t Syste m
to load configuration one (
deault configuration when you reboot. Follow the steps below to reboot the Switch.
In the
1
Ma inte na nc e
configuration file. The following screen displays.
Reboot System: Confirmation
Fig ure 247
Click again and then wait for the Switch to restart. This takes up to two minutes. This does not affect
2 O K
the Switch's configuration.
Click
C o nfig 1
Click
C o nfig 2
Click
Fa c to ry De fa ult
settings on the Switch.
Click
C usto m De fa ult
Switch. If you did not save a
Chapter 39 Maintenance
button in the top of the screen to make the changes take effect.
Sa ve
to save the current configuration settings to
to save the current configuration settings to
to save the current configuration settings to a custom default file on the Switch.
on the top right-hand corner in any screen to save the configuration changes
Sa ve
or button does NOT save the changes permanently. All
Apply Add
allows you to restart the Switch without physically turning the power off. It also allows you
), configuration two (
C o nfig 1
screen, click a configuration button next to
and follow steps 1 to 2 to reboot and load configuration one on the Switch.
and follow steps 1 to 2 to reboot and load configuration two on the Switch.
and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
and follow steps 1 to 2 to reboot and load the last-saved custom default file on the
C usto m De fa ult
GS1920v2 Series User's Guide
C o nfig ura tio n 1
C o nfig ura tio n 2
), a
C o nfig 2
Re b o o t Syste m
file in the web configurator, then the factory default file is
341
on the Switch. These
on the Switch. These
or the factory
C usto m De fa ult
to reboot and load that