ZyXEL Communications GS1920v2 Series User Manual page 103

Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
Fig ure 78
The following table describes the labels in this screen.
Table 32 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
L ABEL DESC RIPT IO N
Interface Select the IPv6 interface you want to configure.
IA Type Select
IA- NA
interface.
Optionally, you can also select
with a Rapid Commit option to obtain information from the DHCPv6 server by a rapid two-
message exchange. The Switch discards any Reply messages that do not include a Rapid
Commit option. The DHCPv6 server should also support the Rapid Commit option to have it work
well.
Options Select
DNS
have the Switch obtain a list of domain names from the DHCP server.
Information Specify the time interval (from 600 to 4294967295 seconds) at which the Switch exchanges other
Refresh configuration information with a DHCPv6 server again.
Minimum
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the nonvolatile memory when you are done configuring.
Cancel Click
C a nc e l
Clear Click
C le a r
Index This is the interface index number. Click on an index number to change the settings.
Interface This is the name of the IPv6 interface you created.
IA-NA This field displays whether the Switch obtains a non-temporary IP address from the DHCPv6 server.
Rapid-Commit This field displays whether the Switch obtains information from the DHCPv6 server by a rapid two-
message exchange.
DNS This field displays whether the Switch obtains DNS server IPv6 addresses from the DHCPv6 server.
Domain-List This field displays whether the Switch obtains a list of domain names from the DHCP server.
Information This field displays the time interval (in seconds) at which the Switch exchanges other configuration
Refresh information with a DHCPv6 server again.
Minimum
Chapter 8 Basic Setting
to set the Switch to get a non-temporary IP address from the DHCPv6 server for this
Ra pid- C o m m it
to have the Switch obtain DNS server IPv6 addresses and/or select
to save your changes to the Switch's run-time memory. The Switch loses these
to begin configuring this screen afresh.
to reset the fields to the factory defaults.
GS1920v2 Series User's Guide
103
to have the Switch send its DHCPv6 Solicit message
link on the top navigation panel to save
Sa ve
to
Do m a in- L ist