Lldp Configuration Org-Specific Tlv Setting - ZyXEL Communications 43222612 User Manual

Table 167 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting (continued)
LABEL
System Name
Apply
Cancel

36.6.2 LLDP Configuration Org-specific TLV Setting

Use this screen to configure organization-specific TLV settings. Click Advanced Application > LLDP > LLDP
Configuration (Click Here) > Org-specific TLV Setting to display the screen as shown next.
Figure 253 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
The following table describes the labels in this screen.
Table 168 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
Port
*
Dot1 TLV
Port-Protocol
VLAN ID
Port VLAN ID
Link
Aggregation
Dot3 TLV
MAC/PHY
Max Frame Size
Chapter 36 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This displays the Switch's port number.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check boxes to enable or disable the sending of IEEE 802.1 Port and Protocol VLAN
ID TLVs on the ports.
Select the check boxes to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the ports. All check boxes in this column are enabled by default.
Select the check boxes to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the ports.
Select the check boxes to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the ports. All check boxes in this column are enabled by default.
Select the check boxes to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs on
the ports.
GS2220 Series User's Guide
333