Table of Contents
Advertisement
Figure 263 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting (Stacking mode)
The following table describes the labels in this screen.
Table 175 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
Slot (Stacking
mode)
Port
Management
Address
Port Description
System
Capabilities
System
Description
System Name
Apply
Cancel
35.6.2 LLDP Configuration Basic Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click Advanced Application >
LLDP > LLDP Configuration > Org-specific TLV Setting to display the screen as shown next.
Chapter 35 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
This displays the Switch's port number.
Select the check box(es) to enable or disable the sending of Management Address TLVs
on the port(s).
Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
Select the check box(es) to enable or disable the sending of System Capabilities TLVs on
the port(s).
Select the check box(es) to enable or disable the sending of System Description TLVs on
the port(s).
Select the check box(es) to enable or disable the sending of System Name TLVs on the
port(s).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
362
Advertisement
Table of Contents
