Mld Snooping-Proxy Vlan - ZyXEL Communications GS1920v2 Series User Manual

Fig ure 152
The following table describes the fields in the above screen.
Table 86 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
L ABEL
MLD Snooping-proxy
Active
802.1p Priority
Apply
Cancel
24.4.2 ML D Sno o ping - pro xy VL AN
Click the
VL AN
screen to display the screen as shown. See
multicasting.
Fig ure 153
Chapter 24 Multicast
Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
DESC RIPT IO N
Use these settings to configure MLD snooping-proxy.
Select Active to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
Select a priority level (0-7) to which the Switch changes the priority in outgoing MLD
messages.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
to save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
link in the
Adva nc e d Applic a tio n > Multic a st > IPv6 Multic a st > ML D Sno o ping - pro xy
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN
GS1920v2 Series User's Guide
Section 24.1 on page 201
212
link on the top navigation panel
Sa ve
for more information on