Pppoe Ia For Vlan - ZyXEL Communications GS1920v2 Series User Manual

The following table describes the labels in this screen.
Table 122 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN
L ABEL
Show Port
Show VLAN
Start VID
End VID
Apply
Port
VID
*
Circuit-id
Remote-id
Apply
Cancel
29.3.3 PPPo E IA fo r VL AN
Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN and whether the
Switch appends the Circuit ID and/or Remote ID to PPPoE discovery packets from a specific VLAN.
Click the
VL AN
Fig ure 196
DESC RIPT IO N
Enter a port number to show the PPPoE Intermediate Agent settings for the specified VLAN(s) on
the port.
Use this section to specify the VLANs you want to configure in the section below.
Enter the lowest VLAN ID you want to configure in the section below.
Enter the highest VLAN ID you want to configure in the section below.
Click to display the specified range of VLANs in the section below.
Apply
This field displays the port number specified above.
This field displays the VLAN ID of each VLAN in the range specified above. If you configure the
VLAN, the settings are applied to all VLANs.
Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Changes in this row are copied to all the VLANs as soon as you make them.
Enter a string of up to 63 ASCII characters that the Switch adds into the Agent Circuit ID sub-
option for this VLAN on the specified port. Spaces are allowed.
The Circuit ID you configure here has the highest priority.
Enter a string of up to 63 ASCII characters that the Switch adds into the Agent Remote ID sub-
option for this VLAN on the specified port. Spaces are allowed.
If you do not specify a string here or in the
automatically uses the PPPoE client's MAC address.
The Remote ID you configure here has the highest priority.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
link in the
Inte rm e dia te Ag e nt
Advanced Application > PPPoE > Intermediate Agent > VLAN
GS1920v2 Series User's Guide
Chapter 29 PPPoE
Re m o te - id
screen to display the screen as shown.
272
field for a specific port, the Switch
link on the top navigation panel to save
Sa ve
*