Ipv6 Interface Setup; Ipv6 Link-Local Address Setup - ZyXEL Communications GS1920v2 Series User Manual

8.10.4 IPv6 Inte rfa c e Se tup
Use this screen to turn on or off an IPv6 interface and enable stateless autoconfiguration on it. Click the
link next to
IPv6 Inte rfa c e Se tup
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
Fig ure 73
The following table describes the labels in this screen.
Table 27 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
L ABEL
Interface
Active
Address
Autoconfig
Apply
Cancel
Clear
Index
Interface
Active
Address
Autoconfig
8.10.5 IPv6 L ink- L o c a l Addre ss Se tup
A link-local address uniquely identifies a device on the local network (the LAN). It is similar to a "private IP
address" in IPv4. You can have the same link-local address on multiple interfaces on a device. A link-
local unicast address has a predefined prefix of fe80::/10.
Use this screen to configure the interface's link-local address and default gateway. Click the link next to
IPv6 L ink- L o c a l Addre ss Se tup
Chapter 8 Basic Setting
in the
IPv6 C o nfig ura tio n
DESC RIPT IO N
Select the IPv6 interface you want to configure.
Select this option to enable the interface.
Select this option to allow the interface to automatically generate a link-local address via
stateless autoconfiguration.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the nonvolatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays whether the IPv6 interface is activated or not.
This field displays whether stateless autoconfiguration is enabled on the interface.
in the
IPv6 C o nfig ura tio n
GS1920v2 Series User's Guide
screen to display the screen as shown next.
link on the top navigation panel to save
Sa ve
screen to display the screen as shown next.
98