Ipv6 Global Address Setup - ZyXEL Communications GS1920v2 Series User Manual

Basic Setting > IPv6 > IPv6 Configuration > IPv6 Link-Local Address Setup
Fig ure 74
The following table describes the labels in this screen.
Table 28 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Link-Local Address Setup
L ABEL
Interface
Link-Local
Address
Default
Gateway
Apply
Cancel
Clear
Index
Interface
IPv6 Link-Local
Address
IPv6 Default
Gateway
8.10.6 IPv6 G lo b a l Addre ss Se tup
Use this screen to configure the interface's IPv6 global address. Click the link next to
in the
Se tup
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Address Setup
Fig ure 75
Chapter 8 Basic Setting
DESC RIPT IO N
Select the IPv6 interface you want to configure.
Manually configure a static IPv6 link-local address for the interface.
Set the default gateway IPv6 address for the interface. When an interface cannot find a routing
information for a frame's destination, it forwards the packet to the default gateway.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the nonvolatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This is the static IPv6 link-local address for the interface.
This is the default gateway IPv6 address for the interface.
screen to display the screen as shown next.
IPv6 C o nfig ura tio n
GS1920v2 Series User's Guide
link on the top navigation panel to save
Sa ve
99
IPv6 G lo b a l Addre ss