Basic Setting; C Ha Pte R 8 Ba Sic Se Tting; Overview; What You Can Do - ZyXEL Communications GS1920v2 Series User Manual

8.1 O ve rvie w
This chapter describes how to configure the
, ,
Se tup Po E Inte rfa c e Se tup
8.1.1 Wha t Yo u C a n Do
• Use the
Syste m Info
• Use the
G e ne ra l Se tup
system name and time.
• Use the
Switc h Se tup
and assign priorities to queues.
• Use the
IP Se tup
device, and the management VLAN ID.
• Use the
Po rt Se tup
• Use the
Po E Sta tus
receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE model(s) only.
• Use the
Inte rfa c e Se tup
interface ID settings.
• Use the
IPv6
• Use the
DNS
• Use the
C lo ud Ma na g e m e nt
C o ntro l Disc o ve ry
8.2 Syste m Info rm a tio n
In the navigation panel, click
to view general system information. You can check the firmware version number.
Chapter 8 Basic Setting
and screens.
IPv6
screen (Section 8.2 on page
screen (Section 8.3 on page
screen (Section 8.5 on page
screen (Section 8.6 on page
screen (Section 8.7 on page
screens (Section 8.8 on page
screens (Section 8.9 on page
screens (Section 8.10 on page
screen (Section 8.11 on page
screen (Section 8.12 on page
and
Ne b ula Switc h Re g istra tio n
Ba sic Se tting
GS1920v2 Series User's Guide
C
Ba sic Se tting
,
Syste m Info G e ne ra l Se tup
77) to check the firmware version number.
79) to configure general settings such as the
82) to choose your VLAN type, set the GARP timers
83) to configure the Switch IP address, default gateway
85) to configure Switch port settings.
87) to view the current amount of power that PDs are
92) to configure Switch interface type and
93) to view IPv6 status and IPv6 configuration.
104) to configure the default domain name server.
104) to display links to
screens.
> to display the screen as shown. Use this screen
Syste m Info
77
HA PTER
, ,
Switc h Se tup IP Se tup
Ne b ula C e nte r
8
,
Po rt