ZyXEL Communications GS1920v2 Series User Manual page 338

IP Application > ARP Setup > ARP Learning
Fig ure 244
The following table describes the labels in this screen.
Table 163 IP Application > ARP Setup > ARP Learning
L ABEL DESC RIPT IO N
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
ARP Learning Select the ARP learning mode the Switch uses on the port.
Mode
Select
ARP- Re ply
requests sent by the Switch.
Select
G ra tuito us- ARP
gratuitous ARP request.
Select
ARP- Re q ue st
ARP requests and ARP requests.
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Chapter 38 ARP Setup
to have the Switch update the ARP table only with the ARP replies to the ARP
to have the Switch update its ARP table with either an ARP reply or a
to have the Switch update the ARP table with both ARP replies, gratuitous
to save your changes to the Switch's run-time memory. The Switch loses these
to begin configuring this screen afresh.
GS1920v2 Series User's Guide
338
link on the top navigation panel to save
Sa ve