Ipv6 Global Setup - ZyXEL Communications GS1920v2 Series User Manual

Table 25 Basic Setting > IPv6 > IPv6 Configuration (continued)
L ABEL
IPv6 Global
Address
Setup
IPv6 Neighbor
Discovery
IPv6
Neighbor
Discovery
Setup
IPv6 Neighbor
Setup
DHCPv6 Client
Setup
8.10.3 IPv6 G lo b a l Se tup
Use this screen to configure the global IPv6 settings. Click the link next to
C o nfig ura tio n
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
Fig ure 72
The following table describes the labels in this screen.
Table 26 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
L ABEL
IPv6 Hop Limit
ICMPv6 Rate
Limit Bucket
Size
ICMPv6 Rate
Limit Error
Interval
Apply
Cancel
Clear
Chapter 8 Basic Setting
DESC RIPT IO N
Click the link to go to a screen where you can configure the IPv6 global address for an interface.
Click the link to go to a screen where you can configure the IPv6 neighbor discovery settings.
Click the link to go to a screen where you can create a static IPv6 neighbor entry in the Switch's
IPv6 neighbor table.
Click the link to go to a screen where you can configure the Switch DHCP settings.
screen to display the screen as shown next.
DESC RIPT IO N
Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is discarded by
an IPv6 router, which is similar to the TTL field in IPv4.
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed to
transmit in a given time interval. If the bucket is full, subsequent error messages are suppressed.
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error messages
of up to the bucket size can be transmitted. 0 means no limit.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the nonvolatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
GS1920v2 Series User's Guide
link on the top navigation panel to save
Sa ve
97
in the
IPv6 G lo b a l Se tup IPv6