Lldp Configuration Org-Specific Tlv Setting - ZyXEL Communications XGS4600 Series User Manual

Figure 312 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting (Stacking Mode)
The following table describes the labels in this screen.
Table 177 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
SLOT
Port
*
Management
Address
Port Description
System Capabilities
System Description
System Name
Apply
Cancel

40.6.2 LLDP Configuration Org-specific TLV Setting

Use this screen to configure organization-specific TLV settings. Click Advanced Application > LLDP > LLDP
Configuration (Click Here) > Org-specific TLV Setting to display the screen as shown next.
Chapter 40 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last two
ports of your Switch) cannot be configured. They are reserved for stacking only.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check boxes to enable or disable the sending of Management Address TLVs on
the ports.
Select the check boxes to enable or disable the sending of Port Description TLVs on the ports.
Select the check boxes to enable or to disable the sending of System Capabilities TLVs on the
ports.
Select the check boxes to enable or to disable the sending of System Description TLVs on the
ports.
Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS4600 Series User's Guide
393