Port Setup - ZyXEL Communications GS1920v2 Series User Manual

Table 16 Basic Setting > IP Setup (continued)
L ABEL
Management IP Addresses
You can create up to 64 IP addresses, which are used to access and manage the Switch from the ports belonging
to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address
IP Subnet Mask
VID
Default Gateway
Add
Cancel
Index
IP Address
IP Subnet Mask
VID
Default Gateway
Delete
Cancel
8.7 Po rt Se tup
Use this screen to configure Switch port settings. Click
to display the configuration screen.
Chapter 8 Basic Setting
DESC RIPT IO N
Enter the IP address for managing the Switch by the members of the VLAN specified in the
field below.
VID
Enter the IP subnet mask in dotted decimal notation.
Type the VLAN group identification number.
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Click to insert the entry to the summary table below and save your changes to the
Add
Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so
use the link on the top navigation panel to save your changes to the non-volatile
Sa ve
memory when you are done configuring.
Click to reset the fields to your previous configuration.
C a nc e l
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays the IP address.
This field displays the subnet mask.
This field displays the ID number of the VLAN group.
This field displays the IP address of the default gateway.
Check the management IP addresses that you want to remove in the
click the button.
De le te
Click to clear the selected check boxes in the
C a nc e l
GS1920v2 Series User's Guide
85
column.
De le te
>
Ba sic Se tting Po rt Se tup
column, then
De le te
in the navigation panel