Table 138 Advanced Application > LLDP > LLDP Configuration
L ABEL
Port
*
Admin Status
Notification
Apply
Cancel
33.6.1 Ba sic T L V Se tting
Use this screen to configure Basic TLV settings. Click
(C lic k He re ) > Ba sic T L V Se tting
Fig ure 215
The following table describes the labels in this screen.
Table 139 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
L ABEL
Port
*
Chapter 33 Link Layer Discovery Protocol (LLDP)
DESC RIPT IO N
This displays the Switch's port number. * means all ports.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select whether LLDP transmission and/or reception is allowed on this port.
•
Disable - not allowed
•
Tx-Only - transmit only
•
Rx-Only - receive only
•
Tx-Rx - transmit and receive
Select whether LLDP notification is enabled on this port.
Click
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click
to begin configuring this screen afresh.
C a nc e l
to display the screen as shown next.
Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
DESC RIPT IO N
This displays the Switch's port number.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
GS1920v2 Series User's Guide
Sa ve
Adva nc e d Applic a tio n
300
link on the top navigation panel to
>
L L DP > L L DP C o nfig ura tio n