Oam Remote Loopback - ZyXEL Communications GS1920v2 Series User Manual

Table 146 Advanced Application > OAM > OAM Configuration (continued)
L ABEL
Mode
Remote
Loopback
Supported
Remote
Loopback
Ignore-Rx
Apply
Cancel
34.4 O AM Re m o te L o o pb a c k
Use this screen to perform a remote-loopback test. In the
display the screen as shown.
Fig ure 223
The following table describes the labels in this screen.
Table 147 Advanced Application > OAM > OAM Remote Loopback
L ABEL
Remote
Loopback Test
Port
Number of
Packet
DESC RIPT IO N
Specify the OAM mode on the port.
Select to allow the port to issue and respond to Ethernet OAM commands.
Ac tive
Select to allow the port to respond to Ethernet OAM commands.
Pa ssive
Select this check box to enable the remote loopback feature on the port. Otherwise, clear the
check box to disable it.
Select this check box to set the Switch to process loopback commands received on the port.
Otherwise, clear the check box to have the Switch ignore loopback commands received on the
port.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Advanced Application > OAM > OAM Remote Loopback
DESC RIPT IO N
Enter the number of the port from which the Switch performs a remote-loopback test.
Define the allowable packet number of the loopback test frames.
GS1920v2 Series User's Guide
Chapter 34 OAM
O AM Sta tus
314
link on the top navigation panel to save
Sa ve
screen click
Re m o te L o o pb a c k
to