ZyXEL Communications GS1920v2 Series User Manual page 131

Advanced Application > Static Multicast Forwarding
Fig ure 103
The following table describes the labels in this screen.
Table 46 Advanced Application > Static Multicast Forwarding
L ABEL DESC RIPT IO N
Active Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Name Type a descriptive name (up to 32 printable ASCII characters) for this static multicast MAC
address forwarding rule. This is for identification only.
MAC Address Enter a multicast MAC address which identifies the multicast group. The last binary bit of the first
octet pair in a multicast MAC address must be 1. For example, the first octet pair 00000001 is 01
and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and 03:00:5e:00:00:27 are valid multicast
MAC addresses.
VID You can forward frames with matching destination MAC address to port(s) within a VLAN group.
Enter the ID that identifies the VLAN group here. If you don't have a specific target VLAN, enter 1.
Port Enter the port(s) where frames with destination MAC address that matched the entry above are
forwarded. You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For
example, enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Add Click
Add
off or loses power, so use the
non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Clear Click
C le a r
Index Click an index number to modify a static multicast MAC address rule for port(s).
Active This field displays whether a static multicast MAC address forwarding rule is active (
( ). You may temporarily deactivate a rule without deleting it.
No
Name This field displays the descriptive name for identification purposes for a static multicast MAC
address-forwarding rule.
MAC Address This field displays the multicast MAC address that identifies a multicast group.
VID This field displays the ID number of a VLAN group to which frames containing the specified
multicast MAC address will be forwarded.
Port This field displays the port(s) within a identified VLAN group to which frames containing the
specified multicast MAC address will be forwarded.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Chapter 11 Static Multicast Forwarding
to save your rule to the Switch's run-time memory. The Switch loses this rule if it is turned
link on the top navigation panel to save your changes to the
Sa ve
to reset the fields to their last saved values.
to begin configuring this screen afresh.
GS1920v2 Series User's Guide
131
) or not
Ye s