Change Your Password - ZyXEL Communications GS1920v2 Series User Manual

Table 7 Navigation Panel Links (continued)
L INK
PPPoE
Errdisable
Private VLAN
Green Ethernet
LLDP
OAM
IP Application
Static Routing
DiffServ
DHCP
ARP Setup
Management
Maintenance
Access Control
Diagnostic
System Log
Syslog Setup
Cluster
Management
MAC Table
ARP Table
Path MTU Table
Configure Clone
IPv6 Neighbor
Table
Port Status
4.3.1 C ha ng e Yo ur Pa sswo rd
After you log in for the first time, it is recommended you change the default administrator password.
Click
Ma na g e m e nt
Chapter 4 The Web Configurator
DESC RIPT IO N
This link takes you to screens where you can configure intermediate agent settings in port,
VLAN, and PPPoE.
This link takes you to screens where you can view errdisable status and configure errdisable
settings in CPU protection, errdisable detect, and errdisable recovery.
This link takes you to a screen where you can configure private VLANs.
This link takes you to a screen where you can configure green Ethernet settings in EEE, auto
power down, and short reach for each port.
This link takes you to screens where you can configure LLDP settings.
This link takes you to screens where you can enable Ethernet OAM on the Switch, view the
configuration of ports on which Ethernet OAM is enabled and perform remote-loopback tests.
This link takes you to a screen where you can configure IPv4 static routes. A static route defines
how the Switch should forward traffic by configuring the TCP/IP parameters manually.
This link takes you to screens where you can enable DiffServ, configure marking rules and set
DSCP-to-IEEE802.1p mappings.
This link takes you to screens where you can configure the DHCP settings.
This link takes you to screens where you can configure the ARP learning settings for each port.
This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
This link takes you to screens where you can change the system login password and configure
SNMP and remote management.
This link takes you to a screen where you can ping IP addresses, run traceroute, test port(s) and
show the Switch's location.
This link takes you to a screen where you can view system logs.
This link takes you to a screen where you can setup system logs and a system log server.
This link takes you to screens where you can configure clustering management and view its
status.
This link takes you to a screen where you can view the MAC addresses (and types) of devices
attached to what ports and VLAN IDs.
This link takes you to a screen where you can view the MAC addresses – IP address resolution
table.
This link takes you to a screen where you can view the path MTU aging time, index, destination
address, MTU, and expire settings.
This link takes you to a screen where you can copy attributes of one port to other ports.
This link takes you to a screen where you can view the IPv6 neighbor table which includes
index, interface, neighbor address, MAC address, status and type.
This link takes you to a screen where you can view the port statistics.
> >
Ac c e ss C o ntro l L o g ins
GS1920v2 Series User's Guide
to display the next screen.
52