Multiple Spanning Tree Protocol Status - ZyXEL Communications GS1920v2 Series User Manual

The following table describes the labels in this screen.
Table 56 Advanced Application > Spanning Tree Protocol > MSTP > Port
L ABEL
MSTP
Port
*
Edge
Apply
Cancel
13.9 Multiple Spa nning T re e Pro to c o l Sta tus
Click
Adva nc e d Applic a tio n
screen as shown next. See
Note: This screen is only available after you activate MSTP on the Switch.
Chapter 13 Spanning Tree Protocol
DESC RIPT IO N
Click to edit MSTP settings on the Switch.
MST P
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding
state immediately without going through listening and learning states right after the port is
configured as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a Bridge
Protocol Data Unit (BPDU).
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
>
Spa nning T re e Pro to c o l
Multiple STP on page 137
GS1920v2 Series User's Guide
150
link on the top navigation panel to
Sa ve
in the navigation panel to display the status
for more information on MSTP.