ZyXEL Communications GS1920v2 Series User Manual page 216

Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Fig ure 155
The following table describes the fields in the above screen.
Table 89 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
L ABEL DESC RIPT IO N
Active Select this option to enable MLD filtering on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Group Limit Select this option to limit the number of multicast groups this port is allowed to join.
Max Group Num. Enter the number of multicast groups this port is allowed to join. Once a port is registered in
the specified number of multicast groups, any new MLD Report message is dropped on this
port.
Filtering Profile Select the name of the MLD filtering profile to use for this port. Otherwise, select
prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the
> Filte ring > Filte ring Pro file
Apply Click
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
Chapter 24 Multicast
screen.
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
to reset the fields to your previous configuration.
C a nc e l
GS1920v2 Series User's Guide
216
Multic a st > IPv6 Multic a st > ML D Sno o ping - pro xy
link on the top navigation panel to
Sa ve
to
De fa ult