ZyXEL Communications GS1920v2 Series User Manual page 221

Advanced Application > Multicast > MVR > Group Configuration
Fig ure 158
The following table describes the labels in this screen.
Table 92 Advanced Application > Multicast > MVR > Group Configuration
L ABEL DESC RIPT IO N
Multicast VLAN ID Select a multicast VLAN ID (that you configured in the
box.
Group Name Enter a descriptive name for identification purposes.
Start Address Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to
End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the
address for a multicast group.
Refer to
Add Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
changes to the non-volatile memory when you are done configuring.
Cancel Click
MVLAN This field displays the multicast VLAN ID.
Group Name This field displays the descriptive name for this setting.
Start Address This field displays the starting IP address of the multicast group.
End Address This field displays the ending IP address of the multicast group.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove, then click the
to select all profiles.
To delete a rule(s) from a profile, select the rule(s) that you want to remove , then click the
De le te
Chapter 24 Multicast
IP Multicast Addresses on page 201
IP Multicast Addresses on page 201
to begin configuring this screen afresh.
C a nc e l
button. You can select the check box in the table heading row
De le te
button.
GS1920v2 Series User's Guide
221
screen) from the drop-down list
MVR
for more information on IP multicast addresses.
field if you want to configure only one IP
Sta rt Addre ss
for more information on IP multicast addresses.
link on the top navigation panel to save your
Sa ve