ZyXEL Communications GS1920v2 Series User Manual page 374

Table 185 Management > Syslog Setup
L ABEL DESC RIPT IO N
Log Level Select the severity level(s) of the logs that you want the device to send to this syslog server.
The lower the number, the more critical the logs are.
Add Click
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
Clear Click
Index This is the index number of a syslog server entry. Click this number to edit the entry.
Active This field displays
device is not to send logs to the syslog server.
IP Address This field displays the IP address of the syslog server.
UDP Port This field displays the port of the syslog server.
Log Level This field displays the severity level of the logs that the device is to send to this syslog server.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click
Cancel Click
to save your changes to the Switch's run-time memory. The Switch loses these
Add
to begin configuring this screen afresh.
C a nc e l
to return the fields to the factory defaults.
C le a r
if the device is to send logs to the syslog server.
Ye s
to remove the selected entry(ies).
De le te
to begin configuring this screen afresh.
C a nc e l
GS1920v2 Series User's Guide
374
link on the top navigation panel to
Sa ve
displays if the
No