Lldp Configuration - ZyXEL Communications GS1920v2 Series User Manual

33.6 L L DP C o nfig ura tio n
Use this screen to configure global LLDP settings on the Switch. Click
L L DP C o nfig ura tio n (C lic k He re )
Advanced Application > LLDP > LLDP Configuration
Fig ure 214
The following table describes the labels in this screen.
Table 138 Advanced Application > LLDP > LLDP Configuration
L ABEL
Active
Transmit Interval
Transmit Hold
Transmit Delay
Reinitialize Delay
Apply
Cancel
Chapter 33 Link Layer Discovery Protocol (LLDP)
to display the screen as shown next.
DESC RIPT IO N
Select to enable LLDP on the Switch. It is enabled by default.
Enter how many seconds the Switch waits before sending LLDP packets.
Enter the time-to-live (TTL) multiplier of LLDP frames. The device information on the
neighboring devices ages out and is discarded when its corresponding TTL expires. The TTL
value is to multiply the TTL multiplier by the LLDP packets transmitting interval.
Enter the delay (in seconds) between successive LLDPDU transmissions initiated by value or
status changes in the Switch MIB.
Enter the number of seconds for LLDP to wait before initializing on a port.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
GS1920v2 Series User's Guide
299
Adva nc e d Applic a tio n
link on the top navigation panel to
Sa ve
>
L L DP >