Laser Safety Warnings - Christie GS Series Service Manual

Laser safety warnings

This product is classified as CLASS 1 LASER PRODUCT - RISK GROUP 2 of IEC60825-1 : 2014 and also
complies with 21 CFR 1040.10 and 1040.11 as a Risk Group 2, LIP (Laser Illuminated Projector) as
defined in IEC 62471:2006 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
Warning! Failure to comply with the following could result in death or serious injury.
• This projector has built-in Class 4 laser module. Never attempt to operate the projector without all
covers properly installed unless instructed to do so in this manual for service.
• Any operation or adjustment not specifically instructed in the User manual creates the risk of
hazardous laser radiation exposure.
• Only Christie qualified technicians who are knowledgeable about the hazards associated with laser
use, high-voltage, and high temperatures generated by the product are authorized to assemble,
install, and service the Christie Laser Projection System.
• Do not look into the projector lens when the laser is on. The extremely high brightness can cause
permanent eye damage.
• When turning on the projector, make sure no one within projection range is looking at the lens.
• Follow the control, adjustment, or operation procedures to avoid damage or injury from exposure
of laser radiation.
• The instructions for the assembly, operation, and maintenance include clear warnings concerning
precautions to avoid possible exposure to hazardous laser radiation.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
Service guidelines
12