Comtech EF Data MBT-5000A Installation And Operation Manual page 53

e. Identify the Ethernet Traffic (M&C) IP Address and firmware information using
Upgrading Firmware
one of the following methods:
Using the MBT-5000A Serial Remote Interface (via the User PC / terminal
emulator program):
•
Firmware Info – Use the <0/SWR? (condensed) or <0/FRW? (detailed)
remote query.
•
Ethernet Traffic IP Address – Use the <0/IPA? remote query.
Using the MBT-5000A Front Panel menus:
•
Ethernet IP Address – Use the CONFIG: Remote  Ethernet  Address
menu branch, as shown in this example:
Ether IP Address/Range:
192.168.001.011/24 (◄ ►▲▼)
•
Firmware Info – Use the SELECT: UTILITY  Firmware  Info 
Image#1 or Image#2  Bulk menu branches, as shown in this example:
Bulk:FW-000303
2.1.X MM/DD/YY
Using the MBT-5000A HTTP Interface (via the User PC Web Browser – use
of this interface indicates the Ethernet Traffic IP Address is already
known):
•
Firmware Info – Use the "Firmware Information" section of the 'Config |
Utility' page, as shown in this example:
MBT-5000A L-Band Up/Down Converter System
4–4
Revision 1
MN-MBT-5000A