Operating Environment; European Union Radio Equipment And Telecommunications Terminal Equipment (R&Tte) Directive (1999/5/Ec) And En 301 489-1; European Union Electromagnetic Compatibility (Emc) Directive (2004/108/Ec) - Comtech EF Data MBT-5000A Installation And Operation Manual

1.2.3

Operating Environment

CAUTION – DO NOT OPERATE THE UNIT IN ANY OF THESE EXTREME
OPERATING CONDITIONS:
•
AMBIENT TEMPERATURES LESS THAN 0° C (32° F) OR MORE THAN 50°C
(122°F).
•
PRECIPITATION, CONDENSATION, OR HUMID ATMOSPHERES OF MORE
THAN 95% RELATIVE HUMIDITY.
•
UNPRESSURIZED ALTITUDES OF MORE THAN 2000 METRES (6561.7 FEET).
•
EXCESSIVE DUST.
•
FLAMMABLE GASES.
•
CORROSIVE OR EXPLOSIVE ATMOSPHERES.
1.2.4 European Union Radio Equipment and Telecommunications
Terminal Equipment (R&TTE) Directive (1999/5/EC) and EN 301 489-1
Independent testing verifies that the unit complies with the European Union R&TTE Directive, its
reference to EN 301 489-1 (Electromagnetic compatibility and Radio spectrum Matters [ERM];
ElectroMagnetic Compatibility [EMC] standard for radio equipment and services, Part 1: Common
technical requirements), and the Declarations of Conformity for the applicable directives,
standards, and practices that follow:
1.2.4.1
Directive (2004/108/EC)
•
Emissions: EN 55022 Class B – Limits and Methods of Measurement of Radio Interference
Characteristics of Information Technology Equipment.
•
Immunity: EN 55024 – Information Technology Equipment: Immunity Characteristics, Limits,
and Methods of Measurement.
•
EN 61000-3-2 – Harmonic Currents Emission
•
EN 61000-3-3 – Voltage Fluctuations and Flicker.
•
Federal Communications Commission Federal Code of Regulation FCC Part 15,
Subpart B. This equipment complies with the limits for a Class A digital device. These limits
are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy. Operation of this
equipment in a residential area is likely to cause harmful interference; in which case, users
are required to correct the interference at their own expense.
CAUTION – TO ENSURE THAT THE UNIT COMPLIES WITH THESE STANDARDS,
OBEY THESE INSTRUCTIONS:
•
Use coaxial cable that is of good quality for connections to the L-Band Type 'N' Rx (receive)
female connector.
•
Use Type 'D' connectors that have back-shells with continuous metallic shielding.
Type 'D' cabling must have a continuous outer shield (either foil or braid, or both). The shield
must be bonded to the back-shell.
•
Operate the unit with its cover on at all times.
Preface
European Union Electromagnetic Compatibility (EMC)
MBT-5000A L-Band Up/Down Converter System
iii
Revision 1
MN-MBT-5000A