Table of Contents
Advertisement
Command
Arguments
(Instruction
Parameter
for Command
Code and
Type
or Response
Qualifier)
to Query
Set RTC
TIM=
6 bytes
Time
Time
TPE=
1 byte
Protocol
Enable
Time
TPS=
15 bytes
Protocol
Server
Serial-based Remote Product Management
Description of Arguments
(Note that all arguments are ASCII numeric codes between 48 and 57)
Command or Query.
Indicates the time from midnight, in the form hhmmss, where:
hh = hours, between 00 and 23;
mm=minutes between 00 and 59, and
ss= seconds between 00 and 59.
Example: <1/TIM=231259'cr'
>0001/TIM='cr''lf'
(time = 23 hours, 12 minutes and 59 seconds since midnight)
Command or Query.
Used to enable or disable the Time Protocol, where:
0 = Time protocol disabled
1 = Time protocol enabled
Example: TPE=1 (Time protocol enabled)
Command or Query.
Used to set the Time Server IP address for the Unit Tx Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the Time server IP address
Example: TPS=192.168.001.005
MBT-5000A L-Band Up/Down Converter System
7–21
Revision 1
Response to
Query
Response to
Command
(Instruction
query
(Target to
Code and
(Target to
Controller)
Qualifier)
Controller)
TIM =
TIM?
TIM=xxxxxx
TIM?
TIM *
(Same format
as Command
arguments)
TPE =
TPE?
TPE=x
TPE?
(See
Description of
Arguments)
TPS=
TPS?
TPS=xx.xxx.xx
x.xxx.yy
TPS?
(See
Description of
Arguments)
MN-MBT-5000A
Advertisement
Table of Contents
