Comtech EF Data MBT-5000A Installation And Operation Manual page 125

Command
Arguments
(Instruction
Parameter for Command
Code and
Type or Response
Qualifier) to Query
Enable ESA= 1 byte
Statistics
Averaging
Enable ESL= 1 byte
Statistics
Logging
Enable ESW= 1 byte
Redundancy
Switch Mode
Retrieve N/A variable length
Firmware
Number
Serial-based Remote Product Management
Description of Arguments
(Note that all arguments are ASCII numeric codes between 48 and 57)
Command or Query.
Enables or Disables averaging of statistics data at a rate of once per second for 10 second. If
disabled, burst values will be logged instead of averaged values.
0 = Disabled
1 = Enabled
Default Value: 0
Example: <1/ESA=0'cr'
>0001/ESA='cr''lf'
Command or Query.
Enables or Disables the statistics logging function.
0 = Disable
1 = Enable
Default Value: 0
Example: <1/ESL=1'cr'
>0001/ESL='cr''lf'
Command or Query.
Turns ON or OFF the redundancy state, where:
0 = Off
1 = On
Default value: 1
Example: <1/ESW=1'cr'
>0001/ESW='cr''lf'
Query only.
Returns the firmware type loaded into the unit.
i = Bulk Image Number (1 or 2)
a = Firmware Image
b = Firmware Revision
c = Firmware Date
MBT-5000A L-Band Up/Down Converter System
7–12
Revision 1
Response to Query Response to
Command (Instruction query
(Target to Code and (Target to
Controller) Qualifier) Controller)
ESA= ESA? ESA=x
ESA?
(Same format
as Command
arguments)
ESL= ESL? ESL=x
ESL?
(Same format
as Command
arguments)
ESW= ESW? ESW=x
ESW?
ESW *
N/A FRW?i FRW={CR}Bo
ot:{CR}abc{CR
}Bulki:{CR}abc
{CR}abc
(See
Description of
Arguments)
MN-MBT-5000A