Table of Contents
Advertisement
Goodrive20-EU series VFD
Function
Name
code
Switch filter
P05.11
time
Virtual terminal
P05.12
setting
Terminal
P05.13
control running
mode
Detailed instruction of parameters
Set the sample filter time of S1 – S4 and HDI
terminals. If the interference is strong, increase
the parameter to avoid wrong operation.
0.000 – 1.000s
0x000 – 0x1FF (0: Disabled, 1: Enabled )
BIT0: S1 virtual terminal
BIT1: S2 virtual terminal
BIT2: S3 virtual terminal
BIT3: S4 virtual terminal
BIT4: S5 virtual terminal
BIT5: S6 virtual terminal
BIT6: S7 virtual terminal
BIT7: S8 virtual terminal
BIT8: HDI virtual terminal
Note: After a virtual terminal is enabled, the state
of the terminal can only be modified through
communication, and the communication address
is 0x200A.
Set the operation mode of the terminals control
0: 2-wire control 1; Combine the enable with the
direction. This mode is widely used. It
determines the rotation direction by the defined
FWD and REV terminals command.
FWD
K1
REV
K2
COM
1: 2-wire control 2; Separate the enable from the
direction. FWD defined by this mode is the
enabling ones. The direction depends on the
state of the defined REV.
Running
FWD
REV
command
OFF
OFF
Stopping
Forward
ON
OFF
running
Reverse
OFF
ON
running
ON
ON
Hold on
59
Function parameters
Default
Modify
value
○
0.010s
◎
0x000
◎
0
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Goodrive20-EU VFD Series and is the answer not in the manual?
Questions and answers
Start stop time
The start-stop time for the INVT Goodrive20-EU VFD Series is not explicitly mentioned in the provided context. However, the "Pre-exciting time" (P03.25) is listed as a parameter that helps improve torque performance during startup, with a setting range of 0.000 to 10.000 seconds. If more specific start-stop time details are needed, they may be found in additional documentation.
This answer is automatically generated