Command Input Format; Header - Keysight Technologies E5260 Series Programming Manual

NOTE

Command Input Format

The GPIB commands of the Keysight E5260/E5270 are composed of a header,
numeric data, and terminator, as shown in the syntax diagram in the following
figure.
E5260/E5270 Control Command Syntax Diagram

Header

Terminator
Terminator is necessary to enter the command to the Keysight E5260/E5270. For the
available terminators, see
Header
The header is the command name, always contains alpha characters, and is not
upper or lowercase sensitive. Some command names also contain an asterisk (*) or
question mark (?). The following figure shows the syntax diagram for a header.
Header Syntax Diagram
*
Keysight E5260/E5270 Programming Guide, Edition 4
;
Separator
,
Numeric Data
SP SP
"Terminator" and "Special Terminator" on page
Alpha Character
(A to Z, a to z)
Programming Basics
Command Input Format
Terminator
SP
SP : Space
1-21.
?
1- 19