Keysight Technologies E5260 Series Programming Manual page 76

NOTE
To Stop Sweep
Output
Remote Mode Functions
Measurement Modes
The WSV command sets the sweep voltage, and the WSI command sets the sweep
current. You can use the same output mode (voltage or current) as the primary
sweep. The start and stop values must have the same polarity for log sweep.
An automatic abort function is available. Refer to
page 2-23.
Even if the automatic abort function is disabled, the E5260/E5270 automatically
stops measurement if power compliance is enabled for the sweep source and the
power compliance or an automatic abort condition is detected.
2- 14 Keysight E5260/E5270 Programming Guide, Edition 4
"Automatic abort Function" on