Keysight Technologies E5260 Series Programming Manual page 189

Category Command
Measurement XE
Execution
Staircase WT
Sweep
WI
Source Setup
WV
WM
Synchronous WSI
Sweep
Source Setup
WSV
Multi channel WNX
Sweep
Source Setup
Pulsed PT
Source Setup
PI
PV
Pulsed Sweep PT
Source Setup
PWI
PWV
WM
Quasi-pulsed BDM
Voltage
Source Setup
BDT
BDV
Keysight E5260/E5270 Programming Guide, Edition 4
Performs measurements, and returns the measurement data; or recovers
from the paused state if the PA/PAX command has been sent. Not
available for the high speed spot measurement.
Sets the hold time, delay time, step delay time, and trigger delay time.
Sets the staircase current sweep source.
Sets the staircase voltage sweep source.
Sets the automatic sweep abort function.
Sets the synchronous current sweep source used with the WI or PWI
command.
Sets the synchronous voltage sweep source used with the WV or PWV
command.
Sets the synchronous current sweep source or synchronous voltage sweep
source used with the WI or WV command.
Sets the hold time, pulse width, pulse period, and trigger delay time.
Sets the pulsed current source.
Sets the pulsed voltage source.
Sets the hold time, pulse width, pulse period, and trigger delay time.
Sets the pulsed current sweep source.
Sets the pulsed voltage sweep source.
Sets the automatic sweep abort function.
Specifies the detection interval, and either voltage or current
measurement.
Specifies the hold time and delay time.
Sets the quasi-pulsed voltage source.
Command Reference
Command Summary
Summary
4- 5