Keysight Technologies E5260 Series Programming Manual page 225

Execution
Conditions
Syntax
Parameters
Example
Statements
NOTE
CA
The CA command performs the self-calibration.
Modules that fail the self-calibration are disabled, and can only be enabled by the
RCV command.
After the CA command, enter the *OPC? command to confirm that the command
execution is completed.
No channel may be in the HIGH VOLTAGE state (forcing more than ±42 V, or
voltage compliance set to more than ±42 V).
To perform the self-calibration correctly, the measurement terminals should be
opened.
CA [slotnum]
slotnum : Slot number that specifies the module to perform the self-calibration.
Integer expression. 1 to 8.
For HPSMU that uses two slots, set the greater slot number. For example, if it is
installed in slot 3 and 4, slotnum must be 4.
If you do not specify slotnum, this command performs the self-calibration for the
mainframe and all modules.
If slotnum specifies the slot that installs no module, this command causes an error.
OUTPUT @E5270;"CA"
OUTPUT @E5270;"*OPC?"
ENTER @E5270;A
To send CA command to Keysight E5270B installed with ASU
If you send the CA command to the E5270B installed with the ASU (Atto Sense and
Switch Unit), the E5270B executes the self-calibration and the 1 pA range offset
measurement for the measurement channels connected to the ASUs. The offset data
is temporarily memorized until the E5270B is turned off, and is used for the
compensation of the data measured by the 1 pA range of the channels. The E5270B
performs the data compensation automatically and returns the compensated data.
Since the E5270B is turned on, if you do not send the CA command, the E5270B
performs the data compensation by using the pre-stored offset data.
Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Reference
4- 41