Keysight Technologies E5260 Series Programming Manual page 192

Command Reference
Command Summary
Category Command
External TGP
Trigger
TGPC
TGSI
TGSO
TGXO
TGMO
OS/OSX
WS/WSX
TM3
Digital I/O ERM
port
ERS?
ERC
Display and RED
keyboard
DFM
SPA
MPA
SCH
MCH
KLC
4- 8
Enables the trigger function for a terminal.
Clears the trigger setting of the specified ports.
Selects the sweep step first or last that ignores the Start Step Output Setup
trigger input set by the TGP port,1,polarity,2 command.
Selects the trigger type, edge or gate, for the Step Output Setup
Completion trigger output set by the TGP port,2,polarity,2 command.
Selects the trigger type, edge or gate, for the Measurement Completion
trigger output set by the TGP port,2,polarity,1 command.
Selects the trigger type, edge or gate, for the Step Measurement
Completion trigger output set by the TGP port,2,polarity,3 command.
Causes the E5260/E5270 to send a trigger signal from a trigger output
terminal.
Enters a wait state until the E5260/E5270 receives an external trigger via
a trigger input terminal.
Enables use of an external trigger to release the PA/PAX state, or to start
measurement if the E5260/E5270 has not been set to the
PA/PAX/WS/WSX state. Or enables trigger set by the TGP
port,terminal,polarity,1.
Changes the digital I/O port assignments.
Returns the digital I/O port status.
Changes the output status of the digital I/O port.
Enables or disables the measurement data display and the setup data
display in the remote mode.
Selects the data display format, scientific or engineering.
Selects the parameter displayed in the Source Data display area.
Selects the parameter displayed in the Measurement Data display area.
Selects the source channel for the data is displayed on the LCD.
Selects the measurement channel for the data is displayed on the LCD.
Locks or unlocks the front panel keys.
Keysight E5260/E5270 Programming Guide, Edition 4
Summary