Keysight Technologies E5260 Series Programming Manual page 191

Category Command
Program ST
Memory
END
SCR
LST?
DO
RU
Query ERR?
EMG?
*IDN?
LOP?
*LRN?
NUB?
*OPC?
UNT?
WNU?
WZ?
Status Byte *SRE
*SRE?
*STB?
Keysight E5260/E5270 Programming Guide, Edition 4
Used with END command to store a program in the internal program
memory. The ST command indicates the beginning of the program.
Used with the ST command to store a program in the internal program
memory. The END command indicates the end of the program.
Scratches the specified program from the internal program memory.
Returns a catalog of internal memory programs or a specific program
listing (3000 commands maximum).
Executes internal memory programs in the order specified.
Executes internal memory programs sequentially.
Returns error codes.
Returns error message for the specified error code.
Returns the instrument model number and the ROM version number.
Returns the operation status of all modules.
Returns channel settings or the E5260/E5270 command parameter
settings.
Returns the number of measurement data items in the output data buffer.
Starts to monitor pending operations, or asks the OPC bit setting.
Returns the model and revision numbers of all modules.
Returns the number of sweep steps specified by the sweep command.
Returns 0 if all channel output is ± 2 V or less, or 1 if any channel applies
more than ± 2 V.
Enables the specified bits of the status byte register.
Returns which bits of the status byte register are enabled.
Returns the status byte setting.
Command Reference
Command Summary
Summary
4- 7