Keysight Technologies E5260 Series Programming Manual page 141

NOTE
Staircase Sweep with Pulsed Bias Measurements
To perform staircase sweep with pulsed bias measurements, use the following
commands.
Function
Enables channels
Disables channels
Sets filter ON/OFF
Sets series resistor ON/OFF
Sets auto abort function
Sets voltage sweep source
Sets current sweep source
Sets synchronous sweep
a
source
Sets pulse timing parameters
Forces pulse voltage
Forces pulse current
Forces constant voltage
Forces constant current
Sets voltage measurement
range
Sets current measurement
range
Selects measurement mode
Sets SMU operation mode
Executes measurement
a. The WSV/WSI command must be entered after the WV/WI command.
Measurement channel performs measurement so that the pulse width and pulse
period are kept. The integration time is automatically set by the instrument, and you
cannot change. For the Keysight E5270B, note that the high-resolution ADC cannot
be used for the pulsed measurements. The AAD/AIT/AV/WT command settings are
ignored.
Keysight E5260/E5270 Programming Guide, Edition 4
Staircase Sweep with Pulsed Bias Measurements
Command
CN [chnum ... [,chnum] ... ]
CL [chnum ... [,chnum] ... ]
[FL] mode[,chnum ... [,chnum] ... ]
[SSR] chnum[,mode]
[WM] abort[,post]
WV chnum,mode,range,start,stop,
step[,comp[,Pcomp]]
WI
[WSV] chnum,range,start,stop
[,comp[,Pcomp]]
[WSI]
PT hold,width,period [,tdelay]
PV chnum,range,base,pulse[,comp]
PI chnum,range,base,pulse [,comp]
DV, TDV chnum,range,output
[,comp[,polarity[,crange]]]
DI, TDI
[RV] chnum,range
[RI] chnum,range
[RM] chnum,mode[,rate]
MM 5,chnum
[CMM] chnum,mode
XE
Programming Examples
Parameters
3- 33