Table of Contents
Advertisement
Execution
Conditions
Syntax
Parameters
Example
Statements
AAD
This command is available for the Keysight E5270B, and is used to specify the A/D
converter (ADC) type, high-speed or high-resolution, for each measurement
channel.
This command setting is ignored by the pulsed spot, pulsed sweep, and staircase
sweep with pulsed bias measurements.
Enter the AIT command to set up the ADC.
This command is not available for the Keysight E5260 series.
AAD chnum[,type]
chnum :
Measurement channel number. The value must be slot number where
the module has been installed. Integer expression. 1 to 8 (1 and 5 are
not available for HPSMU). See
type :
Type of the A/D converter. Integer expression. 0 or 1.
•
0: High-speed ADC (default setting). For high speed measurement.
•
1: High-resolution ADC. For high accurate measurement.
OUTPUT @E5270;"AAD 1,0"
OUTPUT @E5270;"AAD 1,1"
Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Reference
Table 4-1 on page
4-9.
4- 17
Hide quick links:
Advertisement
Table of Contents
