Keysight Technologies E5260 Series Programming Manual page 299

Table 4-12
type terminal
0 1
2
1
a
1
2
2 1
2
3 1
2
a. TM3 command must be entered to use this trigger type.
Example
Statements
See Also
Trigger Type
When a trigger is received, the E5260/E5270 recovers from the wait state set by
the PA, PAX, WS, or WSX command.
The E5260/E5270 sends a trigger by the OS or OSX command.
Start measurement trigger
When a trigger is received, the E5260/E5270 starts the measurement.
Measurement completion trigger
The E5260/E5270 sends a trigger after measurement.
Start step output setup trigger
When a trigger is received, the E5260/E5270 starts the output setup at each
sweep step or the pulsed output setup. This function is available for the staircase
sweep, pulsed sweep, staircase sweep with pulsed bias, multi channel sweep, or
pulsed spot measurement.
Step output setup completion trigger
The E5260/E5270 sends a trigger when the output setup is completed at each
sweep step or the pulsed output setup is completed. This function is available for
the staircase sweep, pulsed sweep, staircase sweep with pulsed bias, multi
channel sweep, or pulsed spot measurement.
Start step measurement trigger
When a trigger is received, the E5260/E5270 starts the measurement at each
sweep step. This function is available for the staircase sweep or multi channel
sweep measurement.
Step measurement completion trigger
The E5260/E5270 sends a trigger after measurement at each sweep step. This
function is available for the staircase sweep or multi channel sweep
measurement.
OUTPUT @E5270;"TGP 1,1,1,2"
See Figure 4-2 on page 4-113
4-117 for a trigger input example.
Keysight E5260/E5270 Programming Guide, Edition 4
Description
for a trigger output example and
Command Reference
Command Reference
Figure 4-3 on page
4- 115