Keysight Technologies E5260 Series Programming Manual page 300

Syntax
Parameters
Remarks
Example
Statements
See Also
Command Reference
Command Reference
TGPC
The TGPC command clears the trigger setting of the specified ports.
TGPC [port[,port...[,port]...]]
A maximum of 18 ports can be set. If no port is specified, the TGPC command
clears the setting of the all ports; Ext Trig In, Ext Trig Out, and digital I/O ports 1 to
16.
port : Trigger port number. Integer expression. -1, -2, or 1 to 16.
-1: Ext Trig In terminal.
-2: Ext Trig Out terminal.
1 to 16: Port 1 to 16 of the digital I/O terminal.
The TGPC command sets the trigger ports as shown below.
Ext Trig In Same as after TGP -1,1,2,0 command execution.
Ext Trig Out Same as after TGP -2,2,2,0 command execution.
Digital I/O Ports No trigger function is available. The ERS? and ERC commands
are available for the port control.
This is not same as the condition set by the *RST command that sets the ports as
shown below.
Ext Trig In Same as after TGP -1,1,2,1 command execution.
Ext Trig Out Same as after TGP -2,2,2,1 command execution.
Digital I/O Ports No trigger function is available. The ERS? and ERC commands
are available for the port control.
OUTPUT @E5270;"TGPC -1,-2,1,2"
"TGP"
4- 116 Keysight E5260/E5270 Programming Guide, Edition 4