Securing Equipment - Huawei NetCol8000-C User Manual

NetCol8000-C(070-260) In-room Chilled Water Smart
Cooling Product
User Manual
Every two modules are connected using eight quick release screws, four on the front door and
four on the rear door.
Step 7 Remove the quick release screws securing the cabinet, disassemble the cabinet, and move the
cabinet inside to the installation position.
Figure 3-22 Removing quick release screws
Step 8 Reassemble the system by performing
Attach the thermal insulation foam to pipe joints after water is injected and air is exhausted.
----End

3.4.6 Securing Equipment

1.
Issue 06 (2020-01-13)
Connect the fan power cable and signal cable, and then bind them using cable ties. The marks on the
terminals should remain the same before and after the disassembling.
Secure the base to the ground using six M12x60 expansion bolts.
Copyright © Huawei Technologies Co., Ltd.
Step 7 to Step 1.
3 Installation Guide
54